GW Instek APS-1102 User Manual - Manual (Page 102)

4.4 Using the Sequence Function
APS-1102 Programmable AC/DC Power Source 4-38
4.4.5 Clear sequence memory
Data is saved to sequence memory automatically. Separate sequence data can be saved for 100 V range
and 200 V range in AC-INT mode and for 100 V range and 200 V range in AC+DC-INT mode.
When clearing the sequence memory, use “MEMORY…” in the SEQUENCE screen.
The operation steps are shown below.
 Operation steps
1. Open the SEQUENCE screen and display the MEMORY EXEC box.
See “4.4.2 Sequence settings”, for description of the sequence for displaying the
MEMORY EXEC box.
2. Press the
ENTER
key to display the EXEC box .
ENTER CANCEL
EXEC box
3. After “CLEAR” has been selected, if the
ENTER
key is pressed, the entire sequence memory is
cleared.
During the memory clear operation (which lasts 5 to 6 seconds) key input can be accepted, but the
operations set by the key is executed after clearing is completed.
 After clearing, initial values are set. (
See “3.2 Display and Initial Settings at
Power-on”.)