GW Instek APS-1102 User Manual - Manual (Page 80)

4.2 Measurement of Inrush Current
APS-1102 Programmable AC/DC Power Source 4-16
4.2.3 Set measurement display to peak value
Set the displayed current measurement value to the peak value (PEAK).
To change the displayed current measurement value, select “MEASURE” in the MISC menu .
 Operation steps
1. Press the or key to move the cursor to the icon, then press the
ENTER
key.
ENTER CANCEL
Cursor
 The MISC menu is displayed.
2. Press the or key to move the cursor to “MEASURE”, then press the
ENTER
key.
 The selection box is displayed.
ENTER CANCEL
Selection box
3. Press the or key to move the cursor to “PEAK”, then press the
ENTER
key.
 This sets the measurement display to the peak value (PEAK).
ENTER CANCEL