GW Instek APS-1102 User Manual - Manual (Page 143)

5.3 SET Menu
APS-1102 Programmable AC/DC Power Source 5-17
Figure 5-7 shows a block diagram of the APS-1102 signal sources.
Figure 5-7. Block Diagram of Signal Sources
 Operation steps
Select
in the SET menu.
See “3.4.2 Setting output mode”, for how to select the output mode.
5.3.2 Output voltage range setting
Select 100 V or 200 V as the output voltage range.
The output voltage range cannot be changed when output is on.
The output voltage setting, current limiter setting, etc., vary according to the output voltage range setting.
See “Table 4-2. Setting Range Options for Various Output Voltage Ranges”.
Output voltage range settings are retained for each operation mode (AC and AC+DC).
 Operation steps
To set the output voltage range, select
in the SET menu.
For description of output voltage range settings:
See “3.4.3 Setting output voltage range”.
See “4.1.3 Setting the output voltage range”.
PLL
To AMP CONTROL
EXT INPUT GAIN EXT
ADD
INT
ADD
SYNC
INT OSC
EXT SIG IN
EXT SYNC
EXT
LINE
LINE
SYNC
SYSTEM CONTROL