GW Instek APS-1102 User Manual - Manual (Page 116)

4.7 Synchronization of Output to External Signal
APS-1102 Programmable AC/DC Power Source 4-52
4. Press the
ENTER
key to select the mode to be set.
ENTER CANCEL
5. Press the or key to move the cursor to the icon, then press the
ENTER
key to
display the selection box.
ENTER CANCEL Selection box
6. Press the or key to move the cursor to “EXT”, then press the
ENTER
key.
 This sets the external sync signal source to external sync signal “EXT”.
ENTER CANCEL
The frequency range for external synchronization is 40 to 500 Hz. Only use settings within this
range.
！
CAUTION