GW Instek APS-1102 User Manual - Manual (Page 41)

3.3 I/O Terminals
APS-1102 Programmable AC/DC Power Source 3-11
3.3.3 External control I/O
The APS-1102 is equipped with an (8-bit) external control I/O connector to enable external control using
digital signal input and status output using digital signals. The connector is a D-sub 25-pin type.
External control I/O
connector
Figure 3-8. External Control I/O Connector
The signals corresponding to the pins in this connector are listed below in “Table 3-3 External
Control I/O Connectors”.