GW Instek APS-1102 User Manual - Manual (Page 36)

3.2 Display and Initial Settings at Power-on
APS-1102 Programmable AC/DC Power Source 3-6
Table 3-2. Settings in Memory (2/2)
Function Setting Initial setting At Power-on
Current limiter
Output peak current
limiter (positive) 100 V range +42.0 A
Backup value
200 V range +21.0 A
Output peak current
limiter (negative) 100 V range 42.0 A
200 V range 21.0 A
Output average
current limiter 100 V range 10.5 A
200 V range 5.3 A
Setting range limit
Positive voltage
setting limit 100 V range +200.0 V
Backup value
200 V range +400.0 V
Negative voltage
setting limit 100 V range 200.0 V
200 V range 400.0 V
Frequency upper limit setting limit 550.0 Hz
Frequency lower limit setting limit 1.0 Hz
External input gain
setting
External input gain
100 V range 100
200 V range 200
Select measurement
display
Measurement display RMS Backup value
Sequence output
Step time 0.1000 s
Backup value
Step operation type Constant (CONST)
Step end phase enable/disable Disable (DISABLE)
Step end phase 0.0
Step termination End (STOP)
Jump steps 0
Jump court 1
Branch steps 0
System settings
Keylock OFF Backup value
Beep ON Backup value
LCD contrast 55
Backup value
LCD display color Blue (BLUE)
Time unit s Backup value
Output on/off at power-on OFF Backup value
External control input enable/disable Disable Backup value