GW Instek APS-1102 User Manual - Manual (Page 25)

2.3 Grounding and Power Supply Connection
APS-1102 Programmable AC/DC Power Source 2-5
 Do not install the APS-1102 in the following locations:
 Location with flammable gas
 An explosion may occur. Never install and use this product in such a location.
 Outdoors, or location exposed to direct sunlight or near a fire or heat source
 The full performance of this product may not be obtained, or failure may occur.
 Location with corrosive gas, moisture, or high humidity
 This product may become corroded or fail.
 Location near an electromagnetic field source, high-voltage device, or power line
 This product may malfunction.
 Location exposed to excessive vibration
 This product may malfunction or fail.
 Location with excessive dust
 In particular, electrically conductive dust may cause failure of this product.
2.3 Grounding and Power Supply Connection
 Be sure to ground the APS-1102.
This product uses a line filter. Be sure to ground this product. Otherwise, an electric shock
may occur.
To prevent an electric shock from occurring, be sure to ground the APS-1102 according to "Electric
Equipment Technical Standard Class D (100
or below) Grounding" or higher.
When the input power line is 100 V AC, use power cord set 1. When a 3-prong power plug that
includes a protective ground contact is connected to a 3-prong power supply outlet, this product is
grounded automatically. Power cord set 1 (Japan version) is rated at 125 V AC.
When the input power line is 200 V AC, use power cord set 2 equipped with a terminal or crimp
contact that suits the type of outlet to be used. Always connect a ground when using power cord set 2.
Power cord set 2 is rated at 250 V AC.
A 3-prong/2-prong conversion adapter is not provided with this product. If a 3-prong/2-prong
conversion adapter is used, the adaptor ground wire must be connected to a ground contact next to the
outlet.
 The power requirements of this product are as follows:
Voltage range: 100 V AC to 230 V AC ±10 % (when at 250 V or less)
Overvoltage category II
！
WARNING