GW Instek APS-1102 User Manual - Manual (Page 242)

8.1 Introduction
APS-1102 Programmable AC/DC Power Source 8-2
8.1 Introduction
This chapter describes the following items.
 Caution points and storage methods for long periods of non-use
 Caution points for transport and when repackaging for transport
See “2.4 Simple Operation Checks”, for description of simple operation checks.
If these operation checks are not passed, request calibration and/or repair from Good Will or its
representative.
8.2 Routine Maintenance
Be sure to install the APS-1102 in a location that meets the installation requirements.
See “2.2 Installation Environment”, for description of the installation requirements.
a) When panel or case is dirty
Wipe clean with a soft cloth. For stubborn dirt, use a cloth that has been dipped in neutral detergent
and then firmly wrung out.
Do not use a cloth treated with a volatile solvent, such as paint thinner or benzene, or a chemically
treated cloth, which may cause discoloration or peeling of paint.