GW Instek APS-1102 User Manual - Manual (Page 22)

2.1 Checking Before Use
APS-1102 Programmable AC/DC Power Source 2-2
2.1 Checking Before Use
Before installing and using the APS-1102, make sure that it has not been damaged during shipment, and
check that all the accessories and all parts of the main unit are included. If anything is missing, contact the
Good Will distributor from which the product was purchased.
 Safety check
To ensure safety in using the APS-1102, the user should read the following sections of this user manual
before using the APS-1102:

“Safety Precautions” (provided at the beginning of this user manual)
 “2.3 Grounding and Power Supply Connection”
 Appearance and accessories check
If an abnormality (such as a flaw or dent) is found on the outside surface of the corrugated box,
carefully check if the product is adversely affected when removing the product from the corrugated
box.
After opening the corrugated box, check the items contained in the box.
If an abnormality such as a flaw or dent is found on the product, or an accessory is missing, contact
Good Will or its representative.
 Appearance check
Check that no abnormalities such as a flaw and dent are found on the panel, controls, connectors, and
so forth.
 Accessories check
The accessories of this product are listed below. Check that there are no missing items and no flaws
are found.
This product contains high-voltage parts. Never remove the cover.
All internal inspections of this product are to be performed only by service technicians qualified by
Good Will Company.
 User Manual (APS-1102 User Manual) 1
 Control software (CD-ROM) 1
 Power cord set 1 (varies depending on destination, 15 A/125 V for Japan) 1
 Power cord set 2 (10 A/250 V, without plug, for Japan, North America,
and Europe only) 1
 Ferrite core (for USB cord) 1
！
WARNING