GW Instek APS-1102 User Manual - Manual (Page 104)

4.4 Using the Sequence Function
APS-1102 Programmable AC/DC Power Source 4-40
The operation steps are described below.
 Operation steps using control panel
1. Open the PROGRAM screen.
The steps for opening the PROGRAM screen are described in “4.4.2 Sequence
settings”.
 Setting step 1
2. Press the key to move the cursor to “DC VOLT”.
ENTER CANCEL
3. Press the
ENTER
key to display the modification box.
ENTER CANCEL
4. Press the and keys to move the cursor to the 10’s place, then turn the MODIFY dial to set
“2”. Next, move the cursor to the 1’s place and turn the MODIFY dial to set “5”.
 This sets “25.0 V”.
Increase Decrease
5. Press the CANCEL or
ENTER
key to close the modification box.