GW Instek APS-1102 User Manual - Manual (Page 209)

6.3 Command Descriptions
APS-1102 Programmable AC/DC Power Source 6-37
 SYSTem:WRELease
This clears a warning. When a warning is cleared, the SET screen is displayed and key input is
enabled. In order for the warning to be cleared, it is necessary that all the factors of the warning
has been removed and it is ready to be cleared.
(If no warning has occurred, or if a warning has occurred but the device is not ready to cancel the
warning, [
200, “Execution error”] error occurs.)
Syntax: SYSTem:WRELease
Parameters: 1
Command example: SYST:WREL 1
Response format: None
Response example: None
(9) PROGram subsystem
 PROGram[:SELected]:EXECute
This controls sequence operations. Control is performed using the STOP (stop), START (run),
HOLD (hold), BRANCH0 (branch 0), or BRANCH1 (branch 1) parameter.
When in AC-EXT, AC-SYNC, AC+DC-EXT, or AC+DC-SYNC mode, sequences cannot be
executed. ([3, “Invalid in this mode”] error occurs.)
When output is off, sequence execution is disabled. ([2, “Invalid with output off”] error occurs.)
Syntax: PROGram[:SELected]:EXECute
Parameters: STOP / START / HOLD / BRANCH0 / BRANCH1
Command example: PROG:EXEC START
Response format: None
Response example: None