GW Instek APS-1102 User Manual - Manual (Page 106)

4.4 Using the Sequence Function
APS-1102 Programmable AC/DC Power Source 4-42
 Setting step 2
10. Press the or key to move the cursor to “STEP”.
11. Press the
ENTER
key to display the modification box.
12. Press the
and keys to move the cursor to 1’s place, then turn the MODIFY dial to set “2”.
The set value will be reflected in output immediately.
13. Press the
CANCEL
or
ENTER
key to close the modification box.
14. Press the key to move the cursor to “TIME”.
15. Press the
ENTER
key to display the modification box.
16. Press the
and keys to move the cursor to the 0.1’s place, then turn the MODIFY dial to set
“2” (this sets “0.2 seconds”). The set value will be reflected in output immediately.
17. Press the
CANCEL
or
ENTER
key to close the modification box.
18. Using the same operations as in steps 2 to 5, set DC VOLT = 25, and using the same operations as
in steps 7 to 9, set the DC voltage operation type as “KEEP”.
Use the same operation steps to set step 3 and subsequent steps.