Caution – GW Instek APS-1102 User Manual User Manual

Page 29

2.4 Simple Operation Checks

APS-1102 Programmable AC/DC Power Source

2-9

2. Panel settings

Set the APS-1102 as shown below.

See “3.4 Main Operation Example”, for descriptors

of the settings methods.

Table 2-1. Panel Settings for Operation Check

Item Setting

Output mode

AC-INT mode

Output voltage range

100 V

AC output voltage

100 Vrms

Selected measurement display RMS

3. Press

the

OUTPUT

key to turn on output.

OUTPUT

Output is off.

Output is on.

⇒

Check that the control panel MEASURE screen shows 100 Vrms as the AC output voltage.

Figure 2-3. Operation Check

⇒

If the normal values are not displayed, it may be due to an operation fault. Contact Good Will

or a Good Will representative.

4. Turn off the power, check that OUTPUT off is displayed, then press the power switch to the bottom

() position. This shuts off the power supply and turns off the power source unit.

Before turning off the power, make sure that the output on/off LED is off.

Output on/off LED is on.

Check display.

！

CAUTION