GW Instek APS-1102 User Manual - Manual (Page 134)

5.2 Basic Operations
APS-1102 Programmable AC/DC Power Source 5-8
Table 5-3. Items in SET Menu
Icon Item Reference
Select output mode See “5.3.1 Output mode setting”.
Select output voltage range
See “5.3.2 Output voltage range
setting”.
Set AC voltage to be output
See “5.3.3 Setting output
voltage ”.
Set DC voltage to be output See “5.3.3 Setting output voltage ”.
Set frequency to be output
See “5.3.4 Setting output
frequency”.
Set phase when output is on
See “5.3.5 Output initial phase
settings”.
Set waveform to be output See “5.3.6 Waveform settings”.
Select external sync signal source
See “4.7 Synchronization of
Output to External Signal”.
Set external input gain
See “4.9 Amplification of External
Signal”.
Set output peak current limit value
(positive) See “5.3.7 Output peak current
limiter settings”.
Set output peak current limit value
(negative) See “5.3.7 Output peak current
limiter settings”.
Set output average current limit value
See “5.3.8 Output average current
limiter settings”.
Set use of other functions, and
miscellaneous items See “Table 5-4. Items in MISC
Menu”.