GW Instek GDS-2000A series Programming Manual - Manual (Page 66)

GDS-2000A Programming Manual
66
:CURSor:VUNI
Description Sets or queries the units for the vertical bar cursors.
Syntax :CURSor:VUNI {BASE | PERcent | ?}
Related
Commands :CURSor:MODe
Parameter BASE Sets the vertical cursor units the same
as the scope units (V or A).
PERcent Sets the displayed units to percent.
Return parameter Returns the unit type.
Example :CURSor:VUNI BASE
Sets the units to the base units.
:CURSor:VUSE
Description Sets the current cursor position as the ratio
reference for the Percent (vertical) cursors.
Note This command can only be used when
:CURSor:VUNI is set to PERcent.
Syntax :CURSor:VUSE {CURRent}
Related
Commands :CURSor:MODe
:CURSor:VUNI
Parameter CURRent Uses the current vertical position
Example :CURSor:VUSE CURRent.
:CURSor:DDT
Description Returns the deltaY/deltaT (dy/dT) readout.
Syntax :CURSor:DDT {?}
Related
Commands :CURSor:MODe
Set
Query
Set
Query