GW Instek GDS-2000A series Programming Manual - Manual (Page 137)

COMMAND DETAILS
137
Return Parameter Returns the address type
Example :TRIGger:BUS:B1:I2C:ADDRess:TYPe?
CBUS
:TRIGger:BUS:B1:I2C:ADDRess:VALue
Description Sets or queries the I 2 C bus address value when the
I 2 C bus is set to trigger on Address or
Address/Data.
Syntax :TRIGger:BUS:B1:I2C:ADDRess:VALue {string | ? }
Related
commands :TRIGger:BUS:B1:I2C:ADDRess:MODe
Parameter 7/10 characters, must be enclosed in
double quotes, "string".
x = don’t care
1 = binary 1
0 = binary 0
Return Parameter Returns the address value.
Example1 :TRIGger:BUS:B1:I2C:ADDRess:VALue "xxx0101"
Sets the address to XXX0101
Example 2 :TRIGger:BUS:B1:I2C:ADDRess:VALue?
XXX0101
:TRIGger:BUS:B1:I2C:ADDRess:DIRection
Description Sets or queries the address bit as read write or
don’t care.
Note This setting only applies when the I 2 C trigger is set
to trigger on Address or Address/Data
Syntax :TRIGger:BUS:B1:I2C:ADDRess:DIRection { READ |
WRITE | NOCARE | ? }
Set
Query
Set
Query