GW Instek GDS-2000A series Programming Manual - Manual (Page 113)

COMMAND DETAILS
113
Run Command
:RUN
Description The run command allows the oscilloscope to
continuously make acquisitions (equivalent to
pressing the Run key on the front panel).
Syntax :RUN
Stop Command
:STOP
Description The stop command stops the oscilloscope making
further acquisitions (equivalent to pressing the
Stop key on the front panel).
Syntax :STOP
Single Command
:SINGle
Description The single command allows the oscilloscope to
capture a single acquisition when trigger
conditions have been fulfilled (equivalent to
pressing the Single key on the front panel).
Syntax :SINGle
Set
Set
Set