GW Instek GDS-2000A series Programming Manual - Manual (Page 64)

GDS-2000A Programming Manual
64
:CURSor:MODe
Description Sets cursor mode to horizontal (H) or horizontal
and vertical (HV).
Note: When the cursor source is set to logic or bus,
then only the horizontal cursor is available.
Syntax :CURSor:MODe {OFF | H | HV | ? }
Parameter OFF Turns the cursors off.
H Turns the horizontal cursors on.
HV Turns horizontal and vertical cursors on.
Return parameter Returns the state of the cursors (H, HV, OFF).
Example :CURSor:MODe OFF
Turns the cursors off.
:CURSor:SOURce
Description Sets or queries the cursor source.
Syntax :CURSor:SOURce {CH1 | CH2 |CH3 | CH4 | REF1 |
REF2 | REF3 | REF4 | MATH | LOGic | BUS1 | ?}
Parameter CH1~CH4 Channel 1 to 4
REF1~4 Reference waveform 1 to 4
MATH Math source
LOGic Logic source
BUS1 Bus source
Return parameter Returns the cursor source.
Example :CURSor:SOURce CH1
Turns the cursor source as channel 1.
Set
Query
Set
Query