GW Instek GDS-2000A series Programming Manual - Manual (Page 170)

GDS-2000A Programming Manual
170
:BUS1:LIN:BITRate .................................................... 182
:BUS1:LIN:IDFORmat ............................................... 182
:BUS1:LIN:POLARity ................................................. 183
:BUS1:LIN:SAMPLEpoint .......................................... 183
:BUS1:LIN:SOURce ................................................... 183
:BUS1:LIN:STANDard ............................................... 184
:BUS1
Description Returns the supported BUS types.
Syntax :BUS1?
Return Parameter Returns the supported bus types.
Example BUS1?
I2C,SPI,UART,Parallel
:BUS1:STATE
Description Sets or queries the state of the bus.
Syntax :BUS1:STATE { OFF | ON | ? }
Related
commands :BUS1:TYPe
Parameter/Return
parameter OFF Turns the bus off.
ON Turns the bus on.
Example :BUS1:STATE ON
Turns the bus on.
:BUS1:TYPe
Description Sets or queries the type of bus.
Syntax :BUS1:TYPe { UART | I2C | SPI | PARallel | ? }
Query
Set
Query
Set
Query