GW Instek GDS-2000A series Programming Manual - Manual (Page 253)

COMMAND DETAILS
253
Go_NoGo Commands
The GoNoGo APP must first be launched (or use the command,
“:GONogo:SCRipt”) before any of the Go_NoGo or Template
commands can be used.
:GONogo:CLEar .........................................................253
:GONogo:EXECute ....................................................253
:GONogo:FUNCtion ..................................................254
:GONogo:NGCount ...................................................254
:GONogo:NGDefine ..................................................254
:GONogo:SOURce .....................................................255
:GONogo:VIOLation ..................................................255
:GONogo:SCRipt .......................................................255
:TEMPlate:MODe ......................................................256
:TEMPlate:MAXimum ................................................256
:TEMPlate:MINimum ................................................256
:TEMPlate:POSition:MAXimum ................................257
:TEMPlate:POSition:MINimum ................................257
:TEMPlate:SAVe:MAXimum ......................................258
:TEMPlate:SAVe:MINimum ......................................258
:TEMPlate:TOLerance ................................................258
:TEMPlate:SAVe:AUTo ...............................................258
:GONogo:CLEar
Description Clears the Go/NoGo counter.
Syntax :GONogo:CLEar
:GONogo:EXECute
Description Enables or disables the Go/NoGo function or
queries its state.
Syntax :GONogo:EXECute {OFF|ON|?}
Set
Set
Query