GW Instek GDS-2000A series Programming Manual - Manual (Page 206)

GDS-2000A Programming Manual
206
RXPARItyerr Set search trigger on RX Parity error
condition.
TXSTArt Set search trigger on the TX Start
Bit.
TXDATA Set search trigger on TX Data.
TXENDPacket Set search trigger on the TX End of
Packet condition.
TXPARItyerr Set search trigger on TX Parity error
condition.
Return Parameter Returns the search triggering condition.
Example :SEARCH:TRIGger:BUS:B1:UART:CONDition TXDATA
Sets the UART bus to trigger on Tx Data for the
search function.
:SEARCH:TRIGger:BUS:B1:UART:RX:DATa:
SIZe
Description Sets or queries the number of bytes for UART data.
Note This setting only applies when the UART search
trigger is set to trigger on Rx Data
Syntax :SEARCH:TRIGger:BUS:B1:UART:RX:DATa:SIZe
{ | ?}
Related
commands :SEARCH:TRIGger:BUS:B1:UART:CONDition
Parameter Number of bytes (1 to 10).
Return parameter Returns the number of bytes.
Example :SEARCH:TRIGger:BUS:B1:UART:RX:DATa:SIZe 5
Sets the number of bytes to 5.
Set
Query