GW Instek GDS-2000A series Programming Manual - Manual (Page 65)

COMMAND DETAILS
65
:CURSor:HUNI
Description Sets or queries the units for the horizontal bar
cursors.
Syntax :CURSor:HUNI {SEConds | HERtz | DEGrees |
PERcent | ?}
Related
Commands :CURSor:MODe
Parameter SEConds Sets the cursor units to time in seconds.
HERtz Sets the cursor units to frequency.
DEGrees Sets the cursor units to degrees.
PERcent Sets the cursor units to percent.
Return parameter Returns the unit type.
Example :CURSor:HUNI SEConds
Sets the units to time in seconds.
:CURSor:HUSE
Description Sets the current cursor position as the phase or
ratio reference for the Percent or Degrees
(horizontal) cursors.
Note This command can only be used when
:CURSor:HUNI is set to DEGrees or PERcent.
Syntax :CURSor:HUSE {CURRent}
Related
Commands :CURSor:MODe
:CURSor:HUNI
Parameter CURRent Uses the current horizontal position
Example :CURSor:HUSE CURRent.
Set
Query
Set