GW Instek GDS-2000A series Programming Manual - Manual (Page 139)

COMMAND DETAILS
139
Parameter The number of characters in the string
depends on the data size setting. The
string must be enclosed in double
quotes, "string".
x = don’t care
1 = binary 1
0 = binary 0
Return Parameter Returns the data value.
Example1 :TRIGger:BUS:B1:I2C:DATa:SIZe 1
:TRIGger:BUS:B1:I2C:DATa:VALue "1x1x0101"
Sets the value to XXX0101
Example 2 :TRIGger:BUS:B1:I2C:DATa:VALue?
1X1X0101
:TRIGger:BUS:B1:UART:CONDition
Description Sets or queries the UART triggering condition.
Syntax :TRIGger:BUS:B1:UART:CONDition { RXSTArt |
RXDATA | RXENDPacket | TXSTArt | TXDATA |
TXENDPacket | TXPARItyerr | RXPARItyerr | ? }
Parameter RXSTArt Set trigger on the RX Start Bit.
RXDATA Set trigger on RX Data.
RXENDPacket Set trigger on the RX End of Packet
condition.
RXPARItyerr Set trigger on RX Parity error
condition.
TXSTArt Set trigger on the TX Start Bit.
TXDATA Set trigger on TX Data.
TXENDPacket Set trigger on the TX End of Packet
condition.
TXPARItyerr Set trigger on TX Parity error
condition.
Set
Query