Brocade Multi-Service IronWare Administration Guide (Supporting R05.6.00) - Manual (Page 79)

Multi-Service IronWare Administration Guide 61
53-1003028-02
Monitoring dynamic memory allocation
2
Miscellaneous elements
Monitoring dynamic memory allocation
After a configured system-max value is accepted, it is possible that the dynamic memory allocation
may fail in a running system. To monitor the amount of available memory on the Management
Module and the Interface Module, a timer will check the memory every 10 seconds. If the available
memory falls below 5 percent of the total installed memory, the timer will log the following warning
message.
The warning message is displayed at a frequency of 1 log per 5 minutes.
NOTE
Notifications and traps are sent.
TABLE 15 Miscellaneous elements
Miscellaneous elements Revertible: yes or no
session-limit yes
ip-filter-sys no
mgmt-port-acl-size no
l2-acl-table-entries no
ipv6-cache yes
ipv6-route yes
IPVRF MAX ROUTES yes
mgmt-port-acl-size no
receive-cam no
IPGRE no
LSP_ACL no
SERVICE_LOOKUP no
IP_SRC_GUARD_CAM no
IPv4 MCAST CAM no
IPv6 MCAST CAM no
SERVER_TRUNKS no
CONFIG_FILE_SIZE no
Brocade# show log
…
Jan 17 22:55:55:N: WARN: Current Total Free Memory on MP is below 5 percent of
Installed Memory.
…
Jan 17 23:53:55:N: WARN: Current Total Free Memory on LP 8 is below 5 percent of
Installed Memory.