Brocade Multi-Service IronWare Administration Guide (Supporting R05.6.00) - Manual (Page 392)

374 Multi-Service IronWare Administration Guide
53-1003028-02
Syslog messages
A
Informational DOT1X Port portnum currently used vlan-id
changes to vlan-id due to dot1x-RADIUS
vlan assignment A user has completed 802.1X
authentication. The profile received from
the RADIUS server specifies a VLAN ID for
the user. The port to which the user is
connected has been moved to the VLAN
indicated by vlan-id.
Informational DOT1X Port portnum currently used vlan-id
is set back to port default vlan-id vlan-id The user connected to portnum has
disconnected, causing the port to be
moved back into its default VLAN, vlan-id.
Informational DOT1X Port portnum is unauthorized
because system resource is not enough or
the invalid information to set the dynamic
assigned IP ACLs or MAC address filters 802.1X authentication could not take place
on the port. This happened because strict
security mode was enabled and one of the
following occurred:
•
Insufficient system resources were
available on the device to apply an IP
ACL or MAC address filter to the port
•
Invalid information was received from
the RADIUS server (for example, the
Filter-ID attribute did not refer to an
existing IP ACL or MAC address filter)
Debug DOT1X Not enough memory There is not enough system memory for
802.1X authentication to take place.
Contact device Technical Support.
TABLE 80 Syslog messages SNMP
Message level Message Explanation
Informational SNMP Auth. failure, intruder IP ip-addr A user has tried to open a management
session with the device using an invalid
SNMP community string.
The ip-addr is the IP address of the host
that sent the invalid community string.
Informational SNMP read-only community | read-write
community | contact | location | user |
group | view | engineld | trap [host] [value
-str] deleted | added | modified from
console | telnet | ssh | web | snmp
session A user made SNMP configuration changes
through the Web, SNMP, console, SSH, or
Telnet session.
[value-str] does not appear in the message
if SNMP community or engineld is specified.
TABLE 81 Syslog messages MPLS
Message level Message Explanation
Informational Deleting VLL name (ID number)at string
port slot/port with peer IPv4 address
ip-address Sent when PW traps are generated if the
PW has been deleted, i.e. when the
pwRowStatus in the MIB has been set to
destroy(6), the PW has been deleted by a
non-MIB application, or due to auto
discovery process.
Informational MPLS Deleting VLL vll-name (ID vll-id) Sent when the specified VLL is being
deleted.
TABLE 79 Syslog messages DOT1X (Continued)
Message level Message Explanation