Brocade Multi-Service IronWare Administration Guide (Supporting R05.6.00) - Manual (Page 355)

Multi-Service IronWare Administration Guide 337
53-1003028-02
Configuring the Syslog service
A
The fan-speed-change option defines the log of changes in the speed of the fan.
The fan-state-change option defines the log of changes in the state of the fan.
The link-state-change option defines the log of changes in the state of the link.
The mgmt-mod-redun-state-change option defines the log of changes in the redundant state of the
management module.
The module-hotswap option defines the log of insertion and removal of modules.
The mpls option defines the log of changes in the state of MPLS VPLS and MPLS VLL.
The mvrp-vlan defines the log of changes in the state of MVRP VLAN.
The ntp option defines the log of changes in the state of the NTP response.
The ospf option defines the log of changes in the state of OSPF.
The snmp-auth-failure option defines the log of SNMP authentication failure events.
The temp-error option defines the log of temporary errors.
The user-login option defines the log of user names for login.
The vrrp-if-state-change option defines the log of changes in the state of VRRP interface.
Specifying a Syslog server
To specify a Syslog server, enter a command such as the following
Brocade(config)# logging host 10.0.0.99
For backward compatibility, the software reads the old command syntax from the startup
configuration, and converts it to the new command syntax in the running configuration.
Syntax: [no] logging host ip-addr | server-name
Specifying an additional Syslog server
To specify an additional Syslog server, enter the logging host ip-addr command again, as in the
following example. You can specify up to six Syslog servers.
Enter a command such as the following
Brocade(config)# logging host 10.0.0.99
For backward compatibility, the software reads the old command syntax from the startup
configuration, and converts it to the new command syntax in the running configuration.
Syntax: [no] logging host ip-addr | server-name
Disabling logging of a message level
If you want to disable the logging of a message level, you must disable each message level
individually.
For example, to disable logging of debugging and informational messages, enter the following
commands
Brocade(config)# no logging buffered debugging