Brocade Multi-Service IronWare Administration Guide (Supporting R05.6.00) - Manual (Page 341)

Multi-Service IronWare Administration Guide 323
53-1003028-02
CAM partition profiles
9
Show cam v6acl
The show cam v6acl command displays IPv6 ACL CAM sessions configured on the device. The
VLAN column is expanded to display either VLAN or IFL ID as shown in the example below:
Syntax: show cam ipv6-vpn slot/port
Displaying IPv6 host drop CAM limit
Run the show ipv6 command to display information about the IPv6 host drop CAM limit.
Syntax: show ipv6
Brocade# show cam v6acl 1/1
LP Index Src IP Addr SPort IFL/VLAN ID
Dst IP Addr DPort Pro Age Out IF PRAM
1 74000 2001:db8:1::/64 0 536977
2001:db8:2::/64 0 6 Dis Pass 000a4
1 74008 2001:db8:1::/64 0 536977
2001:db8:2::/64 0 6 Dis Pass 000a5
1 74010 2001:db8:1::/64 0 536977
2001:db8:2::/6 0 6 Dis Pass 000a6
1 74018 2001:db8:1::/64 0 536977
2001:db8:2::/64 0 6 Dis Pass 000a7
1 74020 2001:db8:1::/64 0 536977
2001:db8:2::/64 0 6 Dis Pass 000a8
1 74028 2001:db8:1::/64 0 536977
Brocade# show ipv6
Global Settings
IPv6 Router-Id: 10.23.23.1 load-sharing path: 4
unicast-routing enabled, ipv6 allowed to run, hop-limit 64
reverse-path-check disabled
host drop cam limit 5
urpf-exclude-default disabled
session-logging-age 5
No Inbound Access List Set
No Outbound Access List Set
source-route disabled, forward-source-route disabled, icmp-redirect disabled
Configured Static Routes: 2