beautypg.com

Accessing the cli, Mac port security level – Brocade Multi-Service IronWare Administration Guide (Supporting R05.6.00) User Manual

Page 26

background image

8

Multi-Service IronWare Administration Guide

53-1003028-02

CONFIG commands

1

MAC port security level

The MAC port security level allows you to configure the port security feature. You reach this level by
entering the port security command at the at the Global or Interface levels.

Accessing the CLI

The CLI can be accessed through both serial and Telnet connections. For initial log on, you must
use a serial connection. Once an IP address is assigned, you can access the CLI through Telnet.

Once connectivity to the device is established, you will see the a prompt.

Brocade>

When accessing the CLI through Telnet, you maybe prompted for a password. By default, the
password required is the password you enter for general access at initial setup. You also have the
option of assigning a separate password for Telnet access with the enable telnet password
password command, found at the Global Level.

At initial log on, all you need to do is type enable at the prompt, then press Return. You only need to
enter a password after a permanent password is entered at the Global CONFIG Level of the CLI.

To reach the Global CONFIG Level, the uppermost level of the CONFIG commands, enter the
following commands

You can then reach all other levels of the CONFIG command structure from this point.

The CLI prompt will change at each level of the CONFIG command structure, to easily identify the
current level.

Brocade> enable

User Level commands

Brocade# configure terminal

Privileged Level-EXEC commands

Brocade(config)#

Global Level-CONFIG commands

Brocade> User Level EXEC Command

Brocade# Privileged Level EXEC Command

Brocade(config)#Global Level CONFIG Command

Brocade(config-if-e10000-5/1)#Interface Level CONFIG Command

Brocade(config-lbif-1)#Loopback Interface CONFIG Command

Brocade(config-ve-1)#Virtual Interface CONFIG Command

Brocade(config-trunk-4/1-4/8)# trunk group CONFIG Command

Brocade(config-if-e10000-tunnel)#IP Tunnel Level CONFIG Command

Brocade(config-bgp-router)#BGP Level CONFIG Command

Brocade(config-dvmrp-router)#DVMRP Level CONFIG Command

Brocade(config-ospf-router)#OSPF Level CONFIG Command

Brocade(config-isis-router)#IS-IS Level CONFIG Command

Brocade(config-pim-router)#PIM Level CONFIG Command

Brocade(config-redundancy)#Redundant Management Module CONFIG Command

Brocade(config-rip-router)#RIP Level CONFIG Command

Brocade(config-port-80)#Application Port CONFIG Command

Brocade(config-bgp-routemap Map_Name)#Route Map Level CONFIG Command

Brocade(config-vlan-1)#VLAN Port-based Level CONFIG Command

Brocade(config-vlan-atalk-proto)#VLAN Protocol Level CONFIG Command