Brocade Multi-Service IronWare Administration Guide (Supporting R05.6.00) - Manual (Page 40)

22 Multi-Service IronWare Administration Guide
53-1003028-02
Entering system administration information
2
Default behavior for certain configuration commands:
Brocade(config)#route-only
This will change the route-only behavior at the global level.
Are you sure? (enter 'y' or 'n'): y
Global 'route-only' committed.
Disabling default behavior to allow for script use:
Brocade(config)#no prompt
Brocade(config)#no route-only
Global 'no route-only' committed.
Re-enabling default behavior:
Brocade(config)#prompt
Brocade(config)#route-only
This will change the route-only behavior at the global level.
Are you sure? (enter 'y' or 'n'): y
Global 'route-only' committed.
Entering system administration information
You can configure a system name, contact, and location for the Brocade device and save the
information locally in the configuration file for future reference. The information is not required for
system operation but recommended. When you configure a system name, it replaces the default
system name in the CLI command prompt.
To configure a system name, contact, and location, enter commands such as the following.
TABLE 6 Interactive commands
Command type Command
Configuration cluster-l2protocol-forward
route-only
rate-limit
policy-map
spanning-tree
pms
disable
enable
violation deny
violation restrict
violation shutdown
Action reboot-standby
reset
reload
switchover
power-off lp all | slot
power-off power-supply index | forced
hitless-reload mp primary | secondary lp
primary | secondary
power-supply monitoring clear all| index
boot system flash primary | secondary