Remote defect indication, Limitations, Sample configuration of remote defect indication – Brocade Multi-Service IronWare Administration Guide (Supporting R05.6.00) User Manual
Page 249

Multi-Service IronWare Administration Guide
231
53-1003028-02
CFM monitoring for ISID
6
Remote Defect Indication
Remote Defect Indication (RDI) is a single bit, is carried by CCM to convey the MEPs in MA about
reception of CCM messages by receiving MEPs (RMEP)
•
The absence of RDI in a CCM indicates that the transmitting MEP is receiving CCMs from all
remote MEPs
•
The presence of RDI indicates that transmitting MEP is not receiving CCM from one or more
RMEPs (one or more RMEP failed is in state) attached to the MEP.
•
RDI is supported for all type of VLANs
•
CVLAN, SVAN, ISID and BVLAN
•
RDI is supported for regular and sub-second CCM intervals
Limitations
•
UPMEP and MIP on C-VLAN ESI is not supported if it is a client of S-VLAN ESI (in Provider Edge).
•
UPMEP and MIP on S-VLAN ESI is not supported if it is a client of ISID ESI (in Backbone Edge).
•
Sub-second CCM interval is not supported for CES.
•
RDI is not applicable for Link MA.
Sample configuration of Remote Defect Indication
The following sample configuration shows the RDI configuration.
Brocade_DUT_1(config)#cfm-enable
Brocade_DUT_1(config-cfm)#domain-name customer level 7
Brocade_DUT_1(config-cfm-md-customer)#ma-name admin vlan-id 100 priority 7
Brocade_DUT_1(config-cfm-md-customer-ma-admin)#ccm-interval 1-second
Brocade_DUT_1(config-cfm-md-customer-ma-admin)#mep 1 down port eth 1/1
Brocade_DUT_2(config)#cfm-enable
Brocade_DUT_2(config-cfm)#domain-name customer level 7
Brocade_DUT_2(config-cfm-md-customer)#ma-name admin vlan-id 100 priority 7
Brocade_DUT_2(config-cfm-md-customer-ma-admin)#ccm-interval 1-second
Brocade_DUT_3(config)#cfm-enable
Brocade_DUT_3(config-cfm)#domain-name customer level 7
Brocade_DUT_3(config-cfm-md-customer)#ma-name admin vlan-id 100 priority 7
Brocade_DUT_3(config-cfm-md-customer-ma-admin)#ccm-interval 1-second
Brocade_DUT_3(config-cfm-md-customer-ma-admin)#mep 2 down port ethe 1/2
Brocade_DUT_4(config)#cfm-enable
Brocade_DUT_4(config-cfm)#domain-name customer level 7
Brocade_DUT_4(config-cfm-md-customer)#ma-name admin vlan-id 100 priority 7
Brocade_DUT_4(config-cfm-md-customer-ma-admin)#ccm-interval 1-second
Brocade_DUT_4(config-cfm-md-customer-ma-admin)#mep 3 down port eth 1/3