Brocade Multi-Service IronWare Administration Guide (Supporting R05.6.00) - Manual (Page 243)

Multi-Service IronWare Administration Guide 225
53-1003028-02
CFM monitoring for ISID
6
Reply from 0000.00ef.2a0b: time= 35.400 us
Reply from 0000.00ef.2a0b: time= 35.115 us
Reply from 0000.00ef.2a0b: time= 35.265 us
Reply from 0000.00ef.2a0b: time= 35.040 us
Reply from 0000.00ef.2a0b: time= 35.265 us
Reply from 0000.00ef.2a0b: time= 35.190 us
Reply from 0000.00ef.2a0b: time= 35.325 us
Reply from 0000.00ef.2a0b: time= 35.280 us
Reply from 0000.00ef.2a0b: time= 35.205 us
sent = 10 number = 10 A total of 10 delay measurement replies received.
Success rate is 100 percent (10/10)
=================================================================================
Round Trip Frame Delay Time : min = 35.040 us avg = 35.238 us max = 35.400 us
Round Trip Frame Delay Variation : min = 45 ns avg = 146 ns max = 285 ns
=================================================================================
Link MA
Link MA can be used to monitor connectivity between any two Links in the network. It can be
configured between any links since it is independent of the VLAN.
• The CCM interval for a sub-second timer is supported for CER with PBIF Support.
• Loopback and delay measurement messages are supported for Link MA.
Configuring Link MA
The below step captures the CFM configuration for Link MA
1. Domain configuration.
Brocade_DUT_1(config-cfm)#domain-name d7 level 7
Syntax: domain-name name lelvel value
2. MA configuration.
Brocade_DUT_1(config-cfm-md-d7)#ma-name link link-ma priority 7
Syntax: ma-name name link-ma priority value
3. MEP configuration.
Brocade_DUT_1(config-cfm-md-d7-ma-link)#mep 1 down port eth 1/1
Syntax: mep ID dir port portID
4. Individual -link monitor configuration.
Brocade(config-cfm-md-erp-ma-ma-erp)#individual-link-monitoring
Syntax: [no] individual-link-monitor