Brocade Multi-Service IronWare Administration Guide (Supporting R05.6.00) - Manual (Page 191)

Multi-Service IronWare Administration Guide 173
53-1003028-02
CFM monitoring and show commands
6
2. To specify a VPLS peer enter a command such as the following.
PE2(config-mpls-vll)vpls-peer 10.1.1.1
3. To specify an un-tagged endpoint for a VLL instance, enter the following commands.
PE2(config-mpls-vll)untagged ethe 2/1
Tagged ports are configured under a VLAN ID.
4. To specify a tagged endpoint for a VLL instance, enter the following commands.
PE2(config-mpls-vll)vlan 30
PE2(config-mpls-vll-vlan)tagged ethe 2/1
IEEE 802.1ag Configurations on PE2
If the VLL configuration is not done prior to configuring the maintenance association, then the
maintenance association is not allowed.
1. To enable CFM, enter the following command.
PE2(config)#cfm-enable
2. Create a maintenance domain with a specified name CUST_1 and level 7.
PE2(config-cfm)#domain-name CUST_1 level 7
3. Create a maintenance association within a specified domain of vll-id 30 with a priority 3.
PE2(config-cfm-md-CUST_1)#ma-name ma_5 vll-id 30 priority 3
4. Set the time interval between successive Continuity Check Messages.The default is
10-seconds.
PE2(config-cfm-md-CUST_1-ma-ma_5)#ccm-interval 10-second
In the above configuration, MIP is created by default on the VLL-endpoint. You can also
configure an explicit-mip on PE2. In that case, MIP is created on the VLL-port if there is a MEP
is created on the endpoint at some lower MD Level.
5. To configure an explicit-mip on PE2, enter the following command.
PE2(config-cfm-md-CUST_1-ma-ma_5)# mip-creation explicit
6. To change back to default use the following command.
PE2(config-cfm-md-CUST_1-ma-ma_5)# mip-creation default
Verifying connectivity using IEEE 802.1ag
Once CE1,CE2,PE1 and PE2 are configured, you can determine the end-to-end connectivity by
looking at the remote-mep status by using the following show commands.
CE1#show cfm connectivity
Domain: CUST_1 Level: 7
Maintenance association: ma_5
CCM interval: 10000 ms
VLAN ID: 30
Priority: 3
RMEP MAC VLAN/PEER AGE PORT SLOTS
==== ==================== ==== ==== ====
2 0000.00e2.8a00 30 879 1/2 1,
CE1#show cfm connectivity domain CUST_1 ma ma_5 rmep-id 2
Domain: CUST_1 Level: 7