Brocade Multi-Service IronWare Administration Guide (Supporting R05.6.00) - Manual (Page 388)

370 Multi-Service IronWare Administration Guide
53-1003028-02
Syslog messages
A
Notification ISIS NbrType neighbor
Hostname/systemID UP on interface-name The device’s Neighbor has come up.
The NbrType can be one of the following:
•
L1
•
L2
•
PTPT
The interface-name is the name of the
interface and is displayed in the following
form “Ethernet 1/1”.
Notification ISIS PTP ADJACENCY DOWN mac on
interface portnum
Notification ISIS PTP ADJACENCY UP mac on interface
portnum
TABLE 75 Definition of IS-IS variables
Variable Value Definition
neighbor-down-reason BFD Trigger BFD identified link failures and triggered IS-IS to clean the
neighbors on that link.
Maximum Adjacencies IS-IS has reached the maximum number of adjacencies.
Therefore, it has deleted the adjacency with the lowest
SNPA address to accommodate the new adjacency.
User Trigger The user triggered to delete the adjacency using the clear
isis neighbor systemID command or the clear isis all
command.
Hold Timer Expiry The adjacency was deleted because there were no “hellos”
received within the hold time period.
Adjacency ID Mismatch The adjacency was deleted because the new “hello”
received from this adjacency has a different System ID.
Adjacency Type
Mismatch The adjacency was deleted because the new “hello”
received from this adjacency has a different adjacency
Type.
Interface Down The adjacency was deleted because the interface went
down.
Interface State Change The adjacency was deleted because the interface state has
changed due to user configuration.
overload-reason Configuration The Overload condition was entered because of a user
configuration.
Startup Configuration The Overload condition was entered because of the startup
configuration.
LSP Buffer Allocation
Failure The Overload condition was entered because of an LSP
buffer allocation error.
LSP Header Allocation
Failure The Overload condition was entered because of an LSP
header allocation error.
Maximum Number of
LSPs Exceeded The Overload condition was entered because the LSP count
reached the maximum value.
TABLE 74 Syslog messages IS-IS (Continued)
Message level Message Explanation