Brocade Multi-Service IronWare Administration Guide (Supporting R05.6.00) - Manual (Page 390)

372 Multi-Service IronWare Administration Guide
53-1003028-02
Syslog messages
A
Error BGP received invalid AS4_PATH attribute
flag (0x40) - entire AS4_PATH ignored If the flag that describes the attribute has
unacceptable values then this error is
displayed.
Error BGP received invalid Confed info in
AS4_PATH (@byte 43) - entire AS4_PATH
ignored Confederation
segments(AS_CONFED_SEQ/SET) must
precede the (AS_SEQ/SET), if not, this error
is displayed.
Error BGP received incorrect Seq type/len in
AS4_PATH (@byte 41) - entire AS4_PATH
ignored Valid segment types are (AS_SEQ/SET,
AS_CONFED_SEQ/SET), any other values
results in an error being displayed.
Error BGP received multiple AS4_PATH attributes
- used first AS4_PATH attribute only When AS4_PATH is received more than one
time in the update message, this error is
displayed.
Warning BGP No of prefixes received from BGP peer
ip-addr exceeds warning limit num The device has received more than the
allowed percentage of prefixes from the
neighbor.
The ip-addr is the IP address of the
neighbor.
The num is the number of prefixes that
matches the percentage you specified. For
example, if you specified a threshold of 100
prefixes and 75 percent as the warning
threshold, this message is generated if the
device receives a 76th prefix from the
neighbor.
Notification BGP Peer ip-addr UP (ESTABLISHED) Indicates that a BGP4 neighbor has come
up.
The ip-addr is the IP address of the
neighbor’s BGP4 interface with the device.
Notification BGP Peer ip-addr DOWN (IDLE) Indicates that a BGP4 neighbor has gone
down.
The ip-addr is the IP address of the
neighbor’s BGP4 interface with the device.
Notification BGP Peer ip DOWN (reasonrecv notif)
Notification Configuration (Wait for BGP) IS-IS is waiting for BGP convergence to
complete.
TABLE 77 Syslog messages NTP
Message level Message Explanation
Warning NTP server ip-addr failed to respond Indicates that a Network Time Protocol
(NTP) server did not respond to the device’s
query for the current time.
The ip-addr indicates the IP address of the
NTP server.
TABLE 76 Syslog messages BGP (Continued)
Message level Message Explanation