Brocade Multi-Service IronWare Administration Guide (Supporting R05.6.00) User Manual
Page 71

Multi-Service IronWare Administration Guide
53
53-1003028-02
Configuring system max values
2
The config-file-size parameter sets the allowed running and startup-config file sizes. Refer to the
appropriate table for your platform. For minimum, maximum and default values for this parameter
refer to
The ifl-cam parameter sets the maximum number of Internal Forwarding Lookup Identifiers. These
are used when configuring a Local VLL for Dual Tagging. The default value for the ifl-cam parameter
is 8K. The maximum values for this parameter are different depending on which CAM partition you
have configured on your system. For minimum, maximum and default values by CAM partition for
this parameter, refer to
The ip-arp parameter sets the maximum number of ARP entries.
For minimum, maximum and default values for this parameter refer to
and
.
The ip-cache parameter sets the maximum size of the IP cache.
For minimum, maximum and default values for this parameter refer to
and
.
The ip-filter-sys parameter sets the maximum number of IP ACL entries.
For minimum, maximum and default values for this parameter refer to
and
.
The ip-route parameter sets the maximum number of IP Route entries.
For minimum, maximum and default values for this parameter refer to
and
.
NOTE
There is no need to configure a system-max value for static ARP entries.
The ip-static-arp parameter sets the maximum number of static ARP entries.
For minimum, maximum and default values for this parameter refer to
.
The ipv4-mcast-cam parameter allows you to configure the maximum CAM size for an IPv4
multicast group. For minimum, maximum and default values for this parameter refer to Table 4.5.
To configure the CAM size of an IPv4 multicast group, refer to
“Configuring CAM size for an IPv4
The ip-subnet-port parameter sets the maximum number of IP subnets per port.
For minimum, maximum and default values for this parameter refer to
and
.
The vrf-route parameter sets the maximum number of VRF routes per VRF instance.
For minimum, maximum and default values for this parameter refer to
.
The ipv6-cache parameter sets the maximum size of the IPv6 cache.
For minimum, maximum and default values for this parameter refer to
.
The ipv6-mcast-cam parameter allows you to configure the maximum CAM size for an IPv6
multicast group. For minimum, maximum and default values for this parameter refer to
. To
configure the CAM size of an IPv6 multicast group, refer to
“Configuring CAM size for an IPv6
The ipv6-route parameter sets the maximum number of IPv6 routes.
For minimum, maximum and default values for this parameter refer to
.
NOTE
The system-max ipv6-route command can be configured with a maximum value of 114688 on the
Brocade MLX series, but the Brocade device system will only support a maximum value of 114687
for IPv6 routes.
The l2-acl-table-entries parameter sets the maximum number of layer-2 ACL entries per ACL table.
For minimum, maximum and default values for this parameter refer to
and
.