Brocade Multi-Service IronWare Administration Guide (Supporting R05.6.00) - Manual (Page 184)

166 Multi-Service IronWare Administration Guide
53-1003028-02
CFM monitoring and show commands
6
1. Create the port-based VLAN that contains the tagged interface that you want to use by entering
the following commands.
RouterC(config)# vlan30
RouterC(config-vlan-30)# tagged ethe 1/1
2. To enable CFM, enter the following command.
RouterC(config)#cfm-enable
3. Create a maintenance domain with a specified name CUST_1 and level 7.
RouterC(config-cfm)#domain-name CUST_1 level 7
4. Create a maintenance association within a specified ESI Site3vlan30, and a vlan-id 30 with a
priority 3.
RouterC(config-cfm-md-CUST_1)#ma-name ma_5 esi Site3vlan30 vlan-id 30 priority
3
5. Set the time interval between successive Continuity Check Messages to 10-seconds.
RouterC(config-cfm-md-CUST_1-ma-ma_5)#ccm-interval 10-second
6. Configuring a MED for each of the Domain Service Access Points of a service instance creates
a MA to monitor the connectivity. Add ethernet port 1/2 to a specified maintenance
association.
RouterC(config-cfm-md-CUST_1-ma-ma_5)#mep 2 down port ethe 1/2
7. To configure the hostnameas RouterC, enter a command such as the following.
RouterC(config)#hostname RouterC
8. Configure interface ethernet 1/1 as the custome-edge by entering the following commands.
RouterC(config)#interface ethernet 1/1
RouterC(config-if-e10000-1/1)#port-type customer-edge
RouterC(config-if-e10000-1/1)enable
RouterC(config-if-e10000-1/1)end
Provider Bridge Brocade1
1. Create the port-based VLAN that contains the tagged interface that you want to use by entering
the following commands.
Brocade1(config)# vlan30
Brocade1(config-vlan-30)# tagged ethe 1/1
2. Create the ESI Brocade1vlan300 as an encapsulated SVLAN with the ESI client Site1vlan30 by
entering the following commands.
Brocade1(config)#esi Brocade1vlan300 encapsulation svlan
Brocade1(config)#esi-client Site1vlan30
3. Add the port-based VLAN300 that contains the tagged interfaces that you want to use by
entering the following commands.
Brocade1(config)# vlan300
Brocade1(config-vlan-300)# tagged ethe 1/1 ethe 1/3
4. To enable CFM, enter the following command.
Brocade1(config)#cfm-enable
5. Create a maintenance domain with a specified name CUST_1 and level 5.