Brocade Multi-Service IronWare Administration Guide (Supporting R05.6.00) - Manual (Page 30)

12 Multi-Service IronWare Administration Guide
53-1003028-02
CONFIG commands
1
NOTE
The vertical bar ( | ) is part of the command.
Note that the regular expression specified as the search string is case sensitive. In the example
above, a search string of “Internet” would match the line containing the IP address, but a search
string of “internet” would not.
Displaying lines that do not contain a specified string
The following command filters the output of the show who command so it displays only lines that
do not contain the word “closed”. This command can be used to display open connections to the
device.
Brocade# show who | exclude closed
Console connections:
established
you are connecting to this session
2 seconds in idle
Telnet connections (inbound):
1 established, client ip address 192.168.9.37
27 seconds in idle
Telnet connection (outbound):
SSH connections:
Syntax: show-command | exclude regular-expression
Displaying lines starting with a specified string
The following command filters the output of the show who command so it displays output starting
with the first line that contains the word “SSH”. This command can be used to display information
about SSH connections to the Brocade.
Brocade# show who | begin SSH
SSH connections:
1 established, client ip address 192.168.9.210
7 seconds in idle
2 closed
3 closed
4 closed
5 closed
Syntax: show-command | begin regular-expression
Searching and filtering output at the --More-- prompt
The --More-- prompt is displayed when output extends beyond a single page. From this prompt, you
can press the Space bar to display the next page, the Return or Enter key to display the next line, or
Ctrl-C or Q to cancel the display. You can also search and filter output from this prompt.