Brocade Multi-Service IronWare Administration Guide (Supporting R05.6.00) - Manual (Page 376)

358 Multi-Service IronWare Administration Guide
53-1003028-02
Syslog messages
A
Notification OSPF intf rcvd bad pkt, rid router-id,
intf addr ip-addr,
pkt src addr src-ip-addr,
pkt type pkt-type Indicates that an OSPF interface received a
bad packet.
The router-id is the router ID of the device.
The ip-addr is the IP address of the
interface on the device.
The src-ip-addr is the IP address of the
interface from which the device received
the authentication failure.
The packet-type can be one of the following:
•
hello
•
database description
•
link state request
•
link state update
•
link state ack
•
unknown
NOTE: This message is typically generated
during BFD or OSPF reconverge
within the following scenarios:
•
The router is undergoing hitless
upgrade
•
Management module switchover,
•
Interface module CPU utilization is at
95% or more,
•
The clear ip ospf neighbor all
command is issued.
During these processes, OSPF adj is
deleted due to BFD time out while the
router can still receive OSPF packets
destined to a previous session from its
neighbor because the neighbor has an
inconsistent OSPF state due to timing. This
message will go away shortly when BFD or
OSPF re-establishes neighbor.
Notification OSPF virtual intf rcvd bad pkt,
rid router-id, intf addr ip-addr,
pkt src addr src-ip-addr,
pkt type pkt-type Indicates that an OSPF interface received a
bad packet.
The router-id is the router ID of the device.
The ip-addr is the IP address of the
interface on the device.
The src-ip-addr is the IP address of the
interface from which the device received
the authentication failure.
The packet-type can be one of the following:
•
hello
•
database description
•
link state request
•
link state update
•
link state ack
•
unknown
TABLE 72 Syslog messages OSPF (Continued)
Message level Message Explanation