Brocade Multi-Service IronWare Administration Guide (Supporting R05.6.00) - Manual (Page 275)

Multi-Service IronWare Administration Guide 257
53-1003028-02
Synthetic loss measurement
6
LER1 Configuration (Initiator)
LER1(config)# cfm
LER1(config-cfm)# cfm loss-measurement slm initiator 1
LER1(config-cfm-loss-measurement-slm-initiator-1)#start now
Stopping synthetic loss measurement sessions:
NOTE
Stop the initiator before stopping the responder.
LER1 Configuration
LER1(config)# cfm
LER1(config-cfm)# cfm loss-measurement slm initiator 1
LER1(config-cfm-loss-measurement-slm-initiator-1)#stop now
LER2 Configuration
LER2(config)# cfm
LER2(config-cfm)# cfm loss-measurement slm responder 1
LER2(config-cfm-loss-measurement-slm-responder-1)#stop now
Show commands
The show cfm loss-measurement slm session_index command is used to display the configuration
data for a specified indices.
Syntax: show cfm loss-measurement slm session index
DUT1# show cfm loss-measurement slm 1
-----------------------------------------------------
SLM Session Index : 1
Status : Stopped
Session Type : Initiator
Domain : d1
MA : m1
Source MEP : 20
Target MEP : 30
Cos : 0
Start time : 16:29:57
Start time type : Immediate
Stop time : 16:30:02
Stop time type : Immediate
Tx-interval (in Sec) : 1
Measurement-Interval : 1
Forward Average : 0
Forward Max : 0
Backward Average : 0
Backward Max : 0
----------------------------------------------------------
TABLE 35 show cfm loss-measurement slm output
Row Definition
SLM Session Index Session index value
Status stopped or running