Brocade Multi-Service IronWare Administration Guide (Supporting R05.6.00) - Manual (Page 255)

Multi-Service IronWare Administration Guide 237
53-1003028-02
Frame Loss Measurement
6
HH:MM:SS starts the session at the indicated time.
HH:MM:SS daily starts the session at the indicated time every day.
No configuration changes are supported once the session is started or triggered. Only the "Stop
now" configuration is allowed which stops the session.
Session will not start if the target MEP not available. Session will be started, only if the target MEP
is in FAILED state or OK state.
Stopping LMM Session Responder
Use the stop command to stop the session responder.
Brocade(config-cfm-loss-measurement-lmm-responder-1)#stop now
Syntax: stop {now | after HH:MM:SS | HH:MM:SS [daily]}
now stops the session immediately.
after HH:MM:SS stops the session after the indicated time interval.
HH:MM:SS stops the session at the indicated time.
HH:MM:SS daily stops the session at the indicated time every day.
Stopping LMM Session Initiator
Use the stop command to stop the session initiator.
Brocade(config-cfm-loss-measurement-lmm-initiator-1)#stop now
Syntax: stop {now | after HH:MM:SS | HH:MM:SS [daily]}
now stops the session immediately.
after HH:MM:SS stops the session after the indicated time interval.
HH:MM:SS stops the session at the indicated time.
HH:MM:SS daily stops the session at the indicated time every day.
Configuration examples
Configuration example for LMM over VLAN
CE-1 Configuration
BrocadeCE-1(config)# cfm
BrocadeCE-1(config-cfm)#loss-measurement lmm initiator 1
BrocadeCE-1(config-cfm-loss-measurement-lmm-initiator-1)#domain md1 ma ma1
src-mep 3 target-mep 4
BrocadeCE-1(config-cfm-loss-measurement-lmm-initiator-1)#Cos 2
BrocadeCE-1(config-cfm-loss-measurement-lmm-initiator-1)#tx-interval 10
BrocadeCE-1(config-cfm-loss-measurement-lmm-initiator-1)#measurement-interval 10
CE-2 Configuration
BrocadeCE-2(config)# cfm
BrocadeCE-2(config-cfm)# loss-measurement lmm responder 1