Brocade Multi-Service IronWare Administration Guide (Supporting R05.6.00) - Manual (Page 362)

344 Multi-Service IronWare Administration Guide
53-1003028-02
Syslog messages
A
Notification System Module was inserted to slot
slot-num Indicates that a module was inserted into a
chassis slot.
The slot-num is the number of the chassis slot
into which the module was inserted.
Notification System Module was removed from slot
slot-num Indicates that a module was removed from a
chassis slot.
The slot-num is the number of the chassis slot
from which the module was removed.
Notification System Set fan speed to speed
percentage Indicates that the fan speed has been changed to
the value described in the speed variable and that
the fan is now operating at the percentage of
capacity described.
The possible speed percentage values are:
•
LOW (50%)
•
MEDIUM (75%)
•
MEDIUM-HIGH (90%)
•
HIGH (100%)
Informational System Cold start The device has been powered on.
Informational System Warm start The system software (flash code) has been
reloaded.
Informational System Interface portnum, state up A port has come up.
The portnum is the port number.
Informational System Interface portnum, state down A port has gone down.
The portnum is the port number.
Informational System Interface portnum, line protocol
up The line protocol on a port has come up.
The portnum is the port number.
Informational System Interface portnum, line protocol
down The line protocol on a port has gone down.
The portnum is the port number.
Informational System Interface portnum is down
(remote fault) The interface is down due to Remote Fault. This is
indicated as “(remote fault)”.
The portnum is the port number of the interface.
Informational System portnum is down (local fault) The port is down due to Local Fault. This is
indicated as “(local fault)”.
The portnum is the port number of the interface.
Informational System Syslog server IP-address deleted |
added | modified from console | telnet |
ssh | web | snmp
OR
Syslog operation enabled | disabled from
console | telnet | ssh | web | snmp A user made Syslog configuration changes to the
specified Syslog server address, or enabled or
disabled a Syslog operation through the Web,
SNMP, console, SSH, or Telnet session.
Informational System SSH | telnet server enabled |
disabled from console | telnet | ssh |
web | snmp session [by user username] A user enabled or disabled an SSH or Telnet
session, or changed the SSH enable or disable
configuration through the Web, SNMP, console,
SSH, or Telnet session.
Informational System Module n CPU m crashed
Informational System IfIndex assignment was changed.) The maximum number of ifIndex per module has
been changed.
TABLE 58 Syslog messages system (Continued)
Message level Message Explanation