Brocade Multi-Service IronWare Administration Guide (Supporting R05.6.00) - Manual (Page 277)

Multi-Service IronWare Administration Guide 259
53-1003028-02
Synthetic loss measurement
6
FLR(ratio) Min : 0.00000
FLR(ratio) Avg : 0.00000
BLR(ratio) Max : 0.00000
BLR(ratio) Min : 0.00000
BLR(ratio) Avg : 0.00000
----------------------------------------------------
Syntax: show cfm loss-measurement slm statistics detailed session_index
DUT1# show cfm loss-measurement slm statistics detailed 1
HISTORY TABLE :
Flag - S:Suspect
------------------------------------------------
Index : 1
Flag : -
Start : 16:29:22
Elapsed : 00:00:05
TxFwd : 5
RxFwd : 5
TxBck : 5
RxBck : 5
FLR(ratio) Max : 0.00000
FLR(ratio) Min : 0.00000
FLR(ratio) Avg : 0.00000
BLR(ratio) Max : 0.00000
BLR(ratio) Min : 0.00000
BLR(ratio) Avg : 0.00000
----------------------------------------------------
Index : 2
Flag : -
Start : 16:29:56
Elapsed : 00:00:05
TxFwd : 5
RxFwd : 5
TxBck : 5
RxBck : 5
FLR(ratio) Max : 0.00000
FLR(ratio) Min : 0.00000
FLR(ratio) Avg : 0.00000
BLR(ratio) Max : 0.00000
BLR(ratio) Min : 0.00000
BLR(ratio) Avg : 0.00000
----------------------------------------------------
Clear history statistics
You can clear history statistics on the initiator side at any time using the following command.
LER1(config)# cfm
LER1(config-cfm)# cfm loss-measurement slm initiator 1
LER1(config-cfm-loss-measurement-slm-initiator-1)#clear-stat
You can clear the history statistics globally using the following command.
NOTE
When this command is executed, history logs will be cleared for all sessions in the system.
LER1(config)# cfm
LER1(config-cfm)# cfm loss-measurement slm clear-stat