Brocade Multi-Service IronWare Administration Guide (Supporting R05.6.00) - Manual (Page 168)

150 Multi-Service IronWare Administration Guide
53-1003028-02
Setting Maintenance Domain parameters
6
Brocade(config-cfm)#domain-name VPLS-SP level 4
Brocade(config-cfm-md-VPLS-SP)#
Syntax: [no] domain-name name [id md-id] [level level]
The domain-name name parameter specifies the domain name. The name attribute is
case-sensitive.
The id md-id is the Maintenance Domain Index. It is an optional parameter. The range is 1 - 4090.
The level parameter sets the domain level in the range 0 – 7. When the domain already exists, the
level argument is optional. The levels are.
Customer’s Domain Levels: 5 - 7
Provider Domain Levels: 3 - 4
Operator Domain Levels: 0 – 2
The no form of the command removes the specified domain from the CFM Protocol Configuration
mode.
Setting Maintenance Domain parameters
Creating Maintenance Associations
The Maintenance Association Identifier is unique over the domain. If the Maintenance Association
Identifier is globally unique, then that domain is global. CFM can detect connectivity errors only for
a list of MEPs with unique MAIDs.
The ma-name command, in Maintenance Domain mode, creates a maintenance association within
a specified domain. The ma-name command changes the Maintenance Domain mode to a Specific
Maintenance Association mode.
Brocade(config-cfm-md-VPLS-SP)# ma-name ma_1 vlan-id 30 priority 4
Brocade(config-cfm-md-VPLS-SP-ma-ma_1)#
Syntax: [no] ma-name name [id ma-id] [esi esi-id] [vlan-id vlan-id][vpls-id vpls-id][priority priority]
The ma-name name parameter specifies the maintenance association name. The NAME attribute
is case-sensitive.
The id ma-id is the Maintenance Association Index. It is an optional parameter. The range is 1 -
4090.
The esi-id specifies a unique ESI identifier of the maintenance association. In case of creating a MA
a ESI ID should be set. This option is available only on platforms that support the Ethernet Service
Instance (ESI) framework.
The vlan-id specifies a unique VLAN identifier of the maintenance association in the range 1-4090.
In case of creating a MA a VLAN ID should be set.
The vpls-id specifies a unique VPLS identifier of the maintenance association. In case of creating a
MA, a VPLS ID should be set.
The priority parameter specifies the priority of the CCM messages, sent by MEPs, in the range 0-7.
When the maintenance association is already created, the priority argument is optional.
The no form of the command removes the created MA.