Brocade Multi-Service IronWare Administration Guide (Supporting R05.6.00) - Manual (Page 401)

Multi-Service IronWare Administration Guide 383
53-1003028-02
Accessing the address family configuration level
B
Accessing the address family configuration level
For example, to access the BGP4 multicast address family configuration level, enter the following
command while at the global BGP configuration level.
Brocade(config-bgp)# address-family ipv4 multicast
Brocade(config-bgp-ipv4m)#
Syntax: address-family ipv4 unicast | ipv4 multicast | ipv6 unicast
The (config-bgp-ipv4m)# prompt indicates that you are at the IPv4 multicast address family
configuration level. At this level, you can access commands that allow you to configure BGP4
multicast routes. The commands that you enter at this level apply to BGP4 multicast routes only.
You can generate a configuration for BGP4 multicast routes that is separate and distinct from
configurations for BGP4 unicast routes and BGP4+ unicast routes.
NOTE
Each address family configuration level gives you access to commands that apply to that address
family only. To enable a feature in a particular address family, you must specify any associated
commands for that feature in that address family.
To exit the BGP4 multicast address family configuration level, enter this command.
Brocade(config-bgp-ipv4m)# exit-address-family
Brocade(config-bgp)#
Syntax: exit-address-family