Brocade Multi-Service IronWare Administration Guide (Supporting R05.6.00) - Manual (Page 389)

Multi-Service IronWare Administration Guide 371
53-1003028-02
Syslog messages
A
LSP Fragmentation
Count Exceeded The Overload condition was entered because of IS-IS trying
to generate the 256th LSP fragment.
LSP Sequence Number
Wrap Around The Overload condition was entered because the LSP
numbers reached the maximum value.
LSP Option Allocation
Failure Self LSP building failed due to an internal buffer allocation
failure.
Path Entry Allocation
Failure The SPF computation failed due to a Path Entry allocation
failure.
Route Entry Allocation
Failure The SPF computation failed due to a Route Entry allocation
failure.
LSP-drop-reason Adjacency not found The LSP was dropped because the is no adjacency found on
the interface.
Adjacency Level
Mismatch The LSP was dropped because the adjacency is at a
different level from the LSP level.
IS Level Mismatch The LSP was dropped because IS-IS is configured at a
different level than the LSP level.
Length Too Short The LSP length is shorter than the LSP header length.
Length Too Large The LSP length is larger than the Maximum LSP buffer
length.
Authentication Failure The LSP was dropped because of an authentication failure.
Max Area Check Failure The LSP has a Max Area Count different than the configured
Max Area Count of the device.
Zero Checksum The LSP has a zero checksum.
Checksum Mismatch The LSP checksum is different than the computed
checksum.
Invalid Length The LSP length is different than the sum of the option
lengths in the LSP.
TABLE 76 Syslog messages BGP
Message level Message Explanation
Debug BGP4 Not enough memory available to run
BGP4 The device could not start the BGP4 routing
protocol because there is not enough
memory available.
Error BGP No of prefixes received from BGP peer
ip-addr exceeds maximum
prefix-limit...shutdown The device has received more than the
specified maximum number of prefixes
from the neighbor, and the device is
therefore shutting down its BGP4 session
with the neighbor.
Error BGP received invalid AS4_PATH attribute
length (3) - entire AS4_PATH ignored Possible attribute length can be only even
number and cannot be odd. If an attribute
with odd length is received, this error is
displayed.
TABLE 75 Definition of IS-IS variables (Continued)
Variable Value Definition