Brocade Multi-Service IronWare Administration Guide (Supporting R05.6.00) - Manual (Page 182)

164 Multi-Service IronWare Administration Guide
53-1003028-02
CFM monitoring and show commands
6
RouterB(config-cfm-md-CUST_1-ma-ma_5)#mep 2 down vlan 30 port ethe 1/1
Configuring Router C
CFM configuration steps for Router C are listed below.
1. To enable CFM for VPLS, enter the following command.
RouterC(config)#cfm-enable
2. Create a maintenance domain with a specified name CUST_1 and level 7.
RouterC(config-cfm)#domain-name CUST_1 level 7
3. Create a maintenance association within a specified domain of vlan-id 30 with a priority 4.
RouterC(config-cfm-CUST_1)#ma-name ma_5 vlan-id 30 priority 4
4. Set the time interval between successive Continuity Check Messages to 10-seconds.
RouterC(config-cfm-md-CUST_1-ma-ma_5)#ccm-interval 10-second
5. Configuring a MED for each of the Domain Service Access Points of a service instance creates
a MA to monitor the connectivity. Add ethernet port 1/1 as MEP to a specified maintenance
association.
Routerc(config-cfm-md-CUST_1-ma-ma_5)#mep 1 down vlan 30 port ethe 1/1
Configuring CFM using Provider Bridges
Below is an example for configuring CFM when using Provider Bridges configurations as in the
figure on
“Sample configuration” on page 162.
Configuring Router A
CFM configuration steps for Router A are listed below.
1. Create the port-based VLAN that contains the tagged interface that you want to use by entering
the following commands.
RouterA(config)# vlan30
RouterA(config-vlan-30)# tagged ethe 1/1
2. To enable CFM, enter the following command.
RouterA(config)#cfm-enable
3. Create a maintenance domain with a specified name CUST_1 and level 7.
RouterA(config-cfm)#domain-name CUST_1 level 7
4. Create a maintenance association within a specified ESI Site1vlan30, and a vlan-id 30 with a
priority 3.
RouterA(config-cfm-md-CUST_1)#ma-name ma_5 esi Site1vlan30 vlan-id 30 priority
3
5. Set the time interval between successive Continuity Check Messages to 10-seconds.
RouterA(config-cfm-md-CUST_1-ma-ma_5)#ccm-interval 10-second