Brocade Multi-Service IronWare Administration Guide (Supporting R05.6.00) - Manual (Page 254)

236 Multi-Service IronWare Administration Guide
53-1003028-02
Frame Loss Measurement
6
6. LMM session threshold configuration
Brocade(config-cfm-loss-measurement-lmm-initiator-1)#threshold forward average
5000 maximum 10000
Brocade(config-cfm-loss-measurement-lmm-initiator-1)#threshold backward average
5000 maximum 10000
Syntax: threshold forward | backward average value maximum value
LMM responder session configuration
Use the following procedure to configure the LMM responder session.
1. LMM responder session creation.
Brocade(config-cfm)#loss-measurement lmm responder 1
Brocade(config-cfm-loss-measurement-lmm-responder-1)#
Syntax: loss-measurement lmm responder session_id
2. LMM responder session configuration.
Brocade(config-cfm-loss-measurement-lmm-responder-1)#domain md1 ma ma1 src-mep 2
target-mep 1
Brocade(config-cfm-loss-measurement-lmm-responder-1)#
Syntax: domain name ma name src-mep id target-mep id
3. LMM session CoS configuration.
Brocade(config-cfm-loss-measurement-lmm-responder-1)#Cos 1
Brocade(config-cfm-loss-measurement-lmm-responder-1)#
Syntax: Cos value
Starting LMM session responder
Use the start command to start the session responder.
Brocade(config-cfm-loss-measurement-lmm-responder-1)#start now
Syntax: start {now | after HH:MM:SS | HH:MM:SS [daily]}
now starts the session immediately.
after HH:MM:SS starts the session after the indicated time interval.
HH:MM:SS starts the session at the indicated time.
HH:MM:SS daily starts the session at the indicated time every day.
Starting LMM Session Initiator
Use the start command to start the session initiator.
Brocade(config-cfm-loss-measurement-lmm-initiator-1)#start after 01:10:00
Syntax: start {now | after HH:MM:SS | HH:MM:SS [daily]}
now starts the session immediately.
after HH:MM:SS starts the session after the indicated time interval.