Brocade Multi-Service IronWare Administration Guide (Supporting R05.6.00) - Manual (Page 369)

Multi-Service IronWare Administration Guide 351
53-1003028-02
Syslog messages
A
Notification AC port fragment packet inspect rate rate
exceeded on port portnum The fragment rate allowed on an individual
interface has been exceeded.
The rate indicates the maximum rate
allowed.
The portnum indicates the port.
This message can occur if fragment
throttling is enabled.
Notification ACL Port portnum, exceed configured L4
rule-based CAM size, larger L4 partition
size required
Notification ACL Port portnum, exceed configured L2
ACL rule-based CAM size, larger partition
size is required
Notification ACL Port portnum, exceed configured
outbound L4 rule-based CAM size, larger
outbound L4 partition size required
Notification ACL Port portnum, exceed configured IPv6
L4 rule-based CAM size, larger IPv6 L4
partition size required
Notification ACL Port portnum, exceed configured IPv6
outbound L4 rule-based CAM size, larger
IPv6 outbound L4 partition size required
Notification ACL Port portnum, error in allocating
inbound L4 rule-based ACL CAM entry
Notification ACL Port portnum, error in allocating
outbound L4 rule-based ACL CAM entry
Notification ACL Port portnum, inbound ACL CAM
programming incomplete
Notification ACL Port portnum, outbound ACL CAM
programming incomplete
Informational ACL aclid added | deleted | modified from
console | telnet | ssh | web | snmp
session A user created, modified, deleted, or
applied an ACL through the Web, SNMP,
console, SSH, or Telnet session.
TABLE 71 Syslog messages RACL
Message level Message Explanation
Notification RACL Port portnum, IP Receive ACL exceed
configured CAM size, larger partition size
required
Notification RACL Port portnum, IP Receive ACL exceed
configured RL class limit
Notification RACL Port portnum, IP Receive ACL CAM
malloc error
TABLE 70 Syslog messages ACL (Continued)
Message level Message Explanation