QNAP TVS-472XT 4-Bay NAS Enclosure - Manual (Page 91)

UI Element Description
Safely Detach Disconnect a RAID device from the NAS when the
device is in NAS Storage mode. QTS will stop and
then safely remove all storage pools, shared folders,
volumes, and LUNs stored on the device, without
deleting any data. You can then connect it to
another NAS or computer.
Tip
To access the storage pools, shared
folders, volumes, and LUNs on another
QNAP NAS, connect the RAID device
to the target NAS, go to Storage &
Snapshots > Disks/VJBOD then select
Recover > Scan all Free Disks .
Important
This button only appears when the
device is in NAS Storage mode.
Eject Safely disconnect a RAID device from the NAS when
the device is in External Storage mode. You can then
connect it to another NAS or computer.
Important
This button only appears when the
device is in External Storage mode.
Configure Create a RAID group on the RAID device and
configure the storage mode.
Important
The RAID device's Mode switch must be
set to Software Control mode.
Check for Update Update the RAID device's firmware, either over the
internet or from a local file. For details, see Manually
Updating External RAID Device Firmware in QTS .
Manage > Configure Spare Disk Configure a global hot spare disk for the RAID
device. If a disk in any RAID group on the device
fails, the hot spare disk will automatically replace the
faulty disk. For details, see Configuring a Spare Disk .
Manage > Remove Delete the RAID group. The member disks will be
automatically assigned as global spare disks if the
device contains any other RAID groups.
Warning
All data on the selected disks will be
deleted.
Manage > View Disks View the information about the disks installed in
the RAID device, including their status and health
information.
Note
Selecting this option takes you to the
Disks/VJBOD screen.
QTS 4.4.x User Guide
Storage & Snapshots 90