QNAP TVS-472XT 4-Bay NAS Enclosure - Manual (Page 196)

Important
QNAP recommends backing up your data before performing this task.
Option Description Steps
Basic system reset This resets the following settings to
the default values without deleting
the user data stored on the disks.
• System administrator password:
MAC address of adapter 1 without
special characters (all letters must
be uppercase). For example, if
the MAC address of adapter 1
is 11:22:33:AA:BB:CC, then the
default admin password will be
112233AABBCC.
Tip
You can find the MAC
address of adapter 1 using
Qfinder Pro. It is also printed
on a sticker on the device as
"MAC1".
• TCP/IP configuration:
• Obtain IP address settings
automatically via DHCP
• Disable jumbo frames
• System port: 8080 (system service
port)
• Security level: Low (Allow all
connections)
• LCD panel password: (blank)
• VLAN: Disabled
• Service binding: All NAS services
can run on all available network
interfaces.
1. Power on the NAS.
2. Press and hold the reset button
for 3 seconds.
QTS 4.4.x User Guide
System Settings 195